Aug 08, 2008 for a watch face that has a day of week, date, and moon calendar: There are two click points on the set-pin. Also if you press and hold the lower left button for at least 3 seconds you can change the way the clock displays date and time. Then you can press the upper right Start button to re-start the seconds at zero. When seconds start flashing, hit a different button to switch to minutes, then hours. Once you get it blinking just push buttons you'll find the ones that do what you need. The wire should be brown and white with a single connector.
What you have to do is to press and hold one of the buttons for at least 3 seconds. You just make sure it's in a place where it can hear the radio signal from Colorado, and if you wait long enough, the watch sets itself to the correct date and time. When the correct hour appears press the lower right button. This will cause the seconds place value begin to blink. To display the current elapsed time, press S2 button again. Holding down the button will speed up the process. .
The split time of the registered lap will be displayed. Change from alarm to date to time by pressing the upper left butt … on again. The problem is it reset but didn't fix the buttons. Holding down the button will speed up the process. Holding down the button will speed up the process. There are 4 button functions on the c9 Champion watch A light , B mode , C start , and D reset. Mar 15, 2010 hold the left, bottom button marked.
Press S1 button again to resume from where it left off. Remove and the animations will start. It depends on what you did and what year. The watch will go into the new mode after about 3 secs. Posted on Dec 02, 2008 I am having the same problem. To set the analog dial, just wait until the second hand is right on 12, and then pull the crown outward.
I say Honda Dealership because the Hon … da pass port uses an Isuzu 3. Connect these together for about 1 second using say a paper clip. You have to unplug it. Screw back on the back cover. The crown is the big knob at the 3-0'clock position.
To change the time, you need to push the mode button 3 times. There are two batteries; one for the animated display and a smaller one for the clock. Holding down the button will speed up the process. To edit another value you press the lower left butto … n and another value will flash. By pressing the reset button you can move to hour, minutes, and seconds.
From the normal time screen. When you are done just press mode again. So now I can't even see the correct time anymore. Press mode again to get back … to the standard time telling function. Once you get this first position set the date to 1 day before the date you want, now pull the stem out to set the time of day, go thru 1, 24 hour cycle to set the date you want and time of day.
Once you have entered the correct time, hit the mode button to allow your watch to start keeping time. The Sportline might be the same or similar. I almost cannot even see it! Remove the back by carefully unscrewing anticlockwise. Rotate the crown until the time on the clock is right, and when you push in the crown, the watch will start running, so try to push the crown … in at the top of the minute. The battery is fine, the seconds are ticking away, but none of the side buttons work.
The only thing that did work was pressing all four of the buttons simultaneously, which seemed to totally reset the watch. After pressing the lower left button three times and the lower right button once you are setting the hour of the time. When an 'H' appears to the right of the time, these are the military hour choices. The date is now set and will change on time, approx. Time the engine with a timing lite, and then plug it back in and the computer takes care of the rest. How To Set the Time For A Timex Watch: First, push the mode button on the bottom left corner for 3 seconds.